How Much Water Does It Takes For Softeners To Regenerate?
Water from your main water pipe or well enters the resin tank of your water softener, where it’s coated with resin beads that are designed to attract and hold onto hard water minerals. After the process is done, softened water exits the resin tank and flows to the plumbing throughout your home.
(Looking for a “water filtration system for kitchen sink“? Contact us Today!)
Resin beads are made of sodium, which conducts an ion swap with the hard minerals in your water. When the resin beads get clogged up with minerals, they can’t do this process properly. That’s when regeneration kicks in, removing the minerals and replenishing the salt in the resin beads to perform their job again.
The regeneration process can take anywhere from 25-70 gallons of water depending on the size of your water softener and how hard your water is.
When your water softener is regenerating, you may not hear any noticeable noises from it. This is because the brine solution that’s being used to flush away the minerals from the resin beads is usually drained off through the discharge hose.
Regeneration is important for water softeners because it’s the only way that they can remove all of the minerals from the resin bed. Without this process, the resin bed would quickly become too heavily inundated with minerals and the system would stop working.
Some water softeners automatically regenerate based on time while others regenerate based on how many gallons of water are consumed in the household. If you’re not sure which method your system uses, refer to your manual or contact the manufacturer/installer.
You can also find a number of websites that will help you determine how often your softener should regenerate, as well as how many gallons of water it will use during the regeneration process. Some even have calculators that allow you to input how many gallons you use in your house and the water hardness level of your area.
If you’re concerned about how much water your water softener will consume during the regeneration process, it’s a good idea to set a timer for it to automatically regenerate after a predetermined amount of water is used in your house. This will ensure that the softener is regenerating after you’ve run out of soft water and will save you a lot of money on your water bill.
One of the best things about the regeneration process is that it’s completely free. This is because the salt that’s being added to the softener during this process only requires a minimal amount of money to pay for.
The amount of salt you need to add to your softener will depend on the hardness of your water, as well as the amount of space available for a brine tank in your home. For instance, if your home is small enough that the brine tank won’t fill up, you’ll only need to add a little bit of salt for the regeneration cycle.