How to Install a Well Water Filtration System? 

If you have a private well for your drinking water, it is essential to install a well water filtration system in order to protect yourself and your family from contaminants such as bacteria, lead, radon, and more. This will not only ensure you get fresh and clean water for your household, but it will also save you money in the long run by keeping your home and appliances working longer.

(Looking for”best water testing services“? Contact us Today!)

How To Install A Well Water Filtration System?

The first step in installing a well water filtration system is to test your well’s water to identify the contaminants it contains. This will help you determine which filtration system is best for your needs and what filters to buy. 

You can use a home water testing kit that is mailed to a lab, or you can use at-home kits with strips that change color when they detect contaminants in the water. These tests can be done quickly and easily, and are the most reliable way to find out what contaminants are present in your well water. 

Next, you will need to choose a location for the filter. Ideally, the installation site should be as close to your well’s point of entry as possible. This will be the most accessible area for the system to be changed, and it should also be near a water shut-off valve. 

Once you’ve found an appropriate spot, turn off the main water supply to your house and cut away a section of your well’s water pipe. Leave a bucket underneath the pipe to catch any water that might leak from the cut section. 

Now that the section of the pipe has been cut away, you will need to replace it with a new one. This will need to be a pipe of the same size as your filter’s inlet and outlet ports, and it should have tees on each end that connect it to your main water line. 

When replacing the pipe, make sure to use the plumber’s tape to prevent any leaks. This will protect your filtration unit and prevent the pipe from bursting. 

In addition to the main pipe, you’ll need to add tees on either side of your filtration unit to connect it to the other water line. This will help keep the unit from moving during use and will allow you to switch off your main supply when you’re changing filters or removing them. 

The tees will be connected to a bypass valve, which you’ll put on when you need to shut off the entire system to change filters. After the valve is installed, you’ll need to add calcite media to your tank. 

This is an alkaline-rich calcium that will help buffer acidic water. This will make your water taste better, and the calcite will provide extra protection against corrosion in the pipes. 

If you’re worried about corrosive chemicals in your well water, check the manufacturer’s instructions for a filter that removes chlorine and chloramines. These can be especially harmful to health if consumed at high levels over a long period of time. You can even purchase whole-house water filters that remove these pollutants or invest in a whole-house reverse osmosis system.