How to Install Water Softeners?

Installing water softeners can be a daunting task. However, if you have a little plumbing experience, installing a new system can be a quick, easy, and affordable process. 

(Searching in Google “McGowan Water Coolers“? Contact us today!)

First, it is important to find a location that is close to the main water line. It is common to have a softener installed near the entry point of the primary water line, often in the garage or basement. 

Second, you should install the water softener near the drain. The unit needs to be close to the drain so that it can be emptied for regeneration. You can choose to have a utility sink installed, a sump pump, or even a floor drain. 

Next, you will need to cut the pipes to fit the water softener. You can use a pipe cutter or a hacksaw. Make sure to choose the right tool for the job. 

If you are installing the softener yourself, make sure to follow the instructions in your manual. This will include the location of the bypass valve. Be sure to place the hose at least two inches above the drain. Also, be sure to plug the softener into a 110V continuous live outlet. 

Once you have completed all of the above steps, you can set the water softener for backwash. Before allowing water to flow through the softener, you should open the valve. While it is possible to do this on your own, you may also need the assistance of a plumber. 

To ensure that your installation goes smoothly, it is a good idea to create a detailed checklist. Having a complete checklist will help you remember to do all of the necessary steps. In addition, a checklist can also prevent you from making any mistakes or missing a step. 

When you are ready to install the softener, you should be able to do it in about an hour. However, this time may vary depending on the size and type of softener you choose to purchase. A whole house water softener will require a permit, and you will need to inspect the building for codes. 

After you have installed the water softener, you should be able start using it. You will need to adjust the salt and potassium chloride levels. Setting the softener to backwash should be easy, but you may also need to consult a professional plumber if you are unsure about the process. 

Finally, you will need to connect the flex lines to your water supply pipes. These can be connected with an adjustable wrench or channel lock pliers. You should also check to make sure that the flex lines are attached to the main pipe. If they are not, you will need to reposition the softener. 

If you have a private well, you will need to shut off the main valve. In addition to shutting off the main water supply, you will need to shut off power to the pump. 

Adding a water softener to your home is not for everyone. But it is a great way to protect your plumbing fixtures from hard water stains.